Abrasive waterjet cutting uses no heat in the cutting process. With no heat affected zones on your part it will save wear on your cutting tools if a finish machining process is required.

Our capabilities for both the waterjet and abrasive jet cutting can cut materials up to 55 x 100 inches. The maximum thickness is 6 to 8 inches depending on materials. Part tolerances over one foot +/- 0.005 part tolerances under on foot +/- 0.003.

Kerf ( taper top to bottom of material) under 3 inches +/- 0.005 over 3 inches +/- .0.008 (smaller kerf can be obtained but with much longer run times). Even with the thickest of materials we are able to rough out a part for final machining which can be very cost effective on larger projects.

View our Materials List